Machined endcap with single O-ring design using Silicone 1/8 inch O-Ring AS568A Dash Number 238 http://www.mcmaster#9396K227

Pressure tested to 120 PSI (270feet aproxmility)
Cad file and PDF attached note work in progress.

OR101_Rev_1.stp

OR101_Rev_1.pdf

Views: 355

Comment

You need to be a member of OPENROV to add comments!

Join OPENROV

Comment by Mark P on February 19, 2013 at 3:11pm

I was thinking about 3/16 O-ring same material.

Next is to test on tubing on high side of tolerance +.030" dia.

Thanks for sample.

Comment by David Lang on February 19, 2013 at 1:42pm

Thanks for postin this Mark! You were planning on using a thicker o-ring, correct? What size were you going for next?

© 2014   Created by Eric Stackpole.

Badges  |  Report an Issue  |  Terms of Service