Well that was was simple enough. I spent a couple of hours today welding the end caps and the bay.

Watched the videos a few times,dry assembled, then glued up.  

 

The end cap weld job looks a bit dodgy. The waterproofing test is going to show just how bad a job I did!

 

End caps

 

 

Views: 166

Comment

You need to be a member of OPENROV to add comments!

Join OPENROV

Comment by Dale Appleton on January 19, 2013 at 1:54pm

Yep, I'm not sure just how complete the glue job is. I did one disc at a time, running the glue in from both the hole, and around the edges. I plan to drip a bit more around the disc edges to see if it wicks in. 

Comment by Ben Kelly on January 19, 2013 at 1:35pm

looks good mate. this is the part im worried about..... very critical part too!

© 2014   Created by Eric Stackpole.

Badges  |  Report an Issue  |  Terms of Service