Builder's Forum (578)

Discussions Replies Latest Activity

Potting motors...

I have not yet started to build my OpenROV 2.6.  However, I have examined the components and the build instructions as well  as some of the…

Started by Ronald Peters

0 53 minutes ago

ESC mounting on PCB

Hi Just wanted to show, a way to mount the ESC´s on the PCB.  Eliminating the wires, saving some space.  It also makes it look more neat,…

Started by Christian Christensen

4 11 hours ago
Reply by Christian Christensen

S/N

Hi together, do I need a serial number for my ROV and where can I get one? Rolf

Started by Rudolf Werner

3 11 hours ago
Reply by Richard Soderberg

Removing residual water from the motors after a dive

All, I pulled the housings off the two horizontal motors and there is some rust on the magnets in spots where it looks like water pooled a…

Started by Jon

7 yesterday
Reply by Ronald Peters

IMU Contact Test

Hello Everyone, I recently did the v2.6 end cap upgrade which required rebuilding the main wire bundle.  I cannot read data from the IMU.  …

Started by quantumquark

2 yesterday
Reply by Richard Soderberg

No Conn, Controller board doesnt boot REVISITED

Suspecting something was shorting (no boot, hot components) I decided to check the cable connections to the DB25-contact. Lacking a proper…

Started by Richard Soderberg

1 yesterday
Reply by Richard Soderberg

No Conn, Controller board doesnt boot, BBB stays off

Hi! I have a rev. 6 board and Li-FePO4 batteries. ROV serial is 1376. When I power up the topside tether adapter the pwr-led and Ethernet-l…

Started by Richard Soderberg

1 yesterday
Reply by Richard Soderberg

Adding the LiPO4 battery settings

Hi, We are using the LiPO4 batteries on our unit. We just completed  the build. What min and max voltage settings do I use so that the batt…

Started by Jon

4 yesterday
Reply by Hubert Kleis

Pool Testing...Chlorine? What should be done before and after dive?

We tested our ROV last week in water for the first time...the pool at our school.  We are wondering about the affect of chlorine if we do m…

Started by Ashley Hallihan

2 on Monday
Reply by Ronald Peters

Ground Station OpenRov

Hello, this is a  prototype of ground station for my  OROV  Blue#17 , whit  aopen mini ATX motherboard ,integrate inverted , HD 17 inch  wi…

Started by jimmy

1 on Monday
Reply by Ronald Peters

RSS

© 2014   Created by Eric Stackpole.

Badges  |  Report an Issue  |  Terms of Service