Forum Discussions (1,223)

Discussions Replies Latest Activity

Adding the LiPO4 battery settings

Hi, We are using the LiPO4 batteries on our unit. We just completed  the build. What min and max voltage settings do I use so that the batt…

Started by Jon in Builder's Forum

4 7 minutes ago
Reply by Hubert Kleis

Removing residual water from the motors after a dive

All, I pulled the housings off the two horizontal motors and there is some rust on the magnets in spots where it looks like water pooled a…

Started by Jon in Builder's Forum

6 3 hours ago
Reply by Paul S

Beaglebone problem?

I have completed the second Openrov and I have been having troubles with the Beaglebone since the first powerup. It would not boot or let m…

Started by Paul S in Onboard Electronics

0 7 hours ago

Pool Testing...Chlorine? What should be done before and after dive?

We tested our ROV last week in water for the first time...the pool at our school.  We are wondering about the affect of chlorine if we do m…

Started by Ashley Hallihan in Builder's Forum

2 11 hours ago
Reply by Ronald Peters

Ground Station OpenRov

Hello, this is a  prototype of ground station for my  OROV  Blue#17 , whit  aopen mini ATX motherboard ,integrate inverted , HD 17 inch  wi…

Started by jimmy in Builder's Forum

1 11 hours ago
Reply by Ronald Peters

[PLUGIN][WIP] Oculus-Rift

This plugin is a work in progress and not finished yet, but would like to start a discussion. My thoughts are that it will work for a singl…

Started by Joakim Karlsson in Cockpit-Plugins

12 yesterday
Reply by Brian A

No Conn, Controller board doesnt boot, BBB stays off

Hi! I have a rev. 6 board and Li-FePO4 batteries. ROV serial is 1376. When I power up the topside tether adapter the pwr-led and Ethernet-l…

Started by Richard Soderberg in Builder's Forum

0 yesterday

Uploading arduino firmware

Lights camara but no action yet. When uploading to arduino I get the following error message Avrdude stk500_rec() programmer is not respon…

Started by Dave Hinton in Builder's Forum

37 on Thursday
Reply by Bob Ivers

I stripped the resin gears in the camera servo

This happened because one of my lasers was a bit too far out, and dragged on the inside of the electronics tube, and I didn't catch it in t…

Started by Michael McCandless in Builder's Forum

1 on Thursday
Reply by David Lang

[PLUGIN] StableRotation

Here is a small plugin that stabilizes the camera's rotation. It uses the the IMU module for the orientation. I haven't test flight it yet…

Started by Joakim Karlsson in Cockpit-Plugins

13 on Thursday
Reply by Tobias Ehn

RSS

© 2014   Created by Eric Stackpole.

Badges  |  Report an Issue  |  Terms of Service